You are here: 10Base-T > Recommended Hardware
Recommended Hardware
Note: The hardware and wiring recommendations listed in this chapter apply to existing 10Base T networks. New installation should use the 100Base T guidelines (see chapter titled Ethernet 100Base T), even if only 10Base T is initially installed. This makes it much easier and less costly to upgrade to 100Base T in the future.
The following hardware is approved for use with Ethernet on NCR Retail workstations. Other hubs that are IEEE 802.3 compliant may also be used.
|
•
|
AT&T 4261-1001-0000 StarLAN 10 Network Hub Unit |
|
•
|
AT&T 451A Adapter (103-7862400) (connects two modular cords) |
|
•
|
NCR Ethernet device drop cable |
|
•
|
497-0008623 (7054, 7452, 7453) |
|
•
|
497-0008905 (7052 only) |
|
•
|
NCR 1008-A077 (250-0030764) |
|
•
|
AT&T WE 103A (105 164 8180) |
|
•
|
AT&T 1100 Modular Jack Panel |
|
•
|
NCR StarLAN Junction Box 1008-A076 (250-0030765) |
|
•
|
NCR Patch cable (65 cm, 18 in.) (250-0030405) |
Note: Other hardware can be used, provided it is rated EIA/TIA Category 3 or better.